for Starlink DC Power Cord Extender, DC Female to Female Coupler

Obeaming for Starlink DC Power Cord Extender, DC Female to Female Coupler 1.5mm Ultra Thin Flat Design, Window and Door Pass Through, DC to DC Female Adapter, for RV Van Truck Camping Off Grid

Flat Profile Slides Through Window and Door Gaps: A round coupler holds the seal open and leaves a gap. This 1.5mm thin flat Starlink Mini DC adapter slides through a closed window or door seal instead, so you can route power outside without leaving an opening for rain, wind, or bugs. Keeps your dish powered while the cabin stays sealed

Made for Van Life, RV Travel, and Truck Camping: Run the flat cord from your indoor power source out to a dish mounted on the roof, ladder, or tripod, then close the door on it. At a crowded campsite where the dish needs to sit further out for clear sky, this 9.8 inch extension bridges the gap between your cable and your outlet

Compact Specs: Measures 9.8 inch (300mm) end to end with a 1.5mm flat profile in grey. IP65 rated against dust and water spray, so splashes and road spray are not a problem. The flat jacket keeps bends clean and resists kinking when you coil it up for storage, and it fits in a glovebox or a door pocket

Built for Starlink Mini Owners Who Travel: RVers, van dwellers, overlanders, truckers, and boaters. Ideal when the dish sits outside on the roof or a tripod but the power lives inside the cabin, and every inch of cable routing matters. Also works for a dish that lives on a balcony, porch, or boat deck

For Cars, Trucks, RVs, Vans, and Boats: Built for road trips, overlanding, van life, and mobile work setups where the dish rides with you. The IP66 water resistant jacket handles rain and road spray on the outside run, so you can keep the dish mounted while you drive. Works with a 12V socket, a 24V truck outlet, or a portable power station

What Is in the Box: 1 x flat DC extension adapter in grey, 9.8 inch long. A clean, low profile look that disappears along a door frame instead of hanging out of the gap. Keep it coiled in the glovebox so it is ready the next time you move the dish or swap power sources. If anything is not right with your order, contact us through Amazon and we will sort it out.